бардык категориялар
EN

Продукт жаңылыктары

Сен бул жерде : Үй> жаңылык > Продукт жаңылыктары

PVC wallpaper cleaning and maintenance

Убактысы: 2022-12-20 Hits: 6

1, the situation of wallpaper blistering Wallpaper blistering is a common problem, however, is mainly due to the uneven application of glue when pasting wallpaper caused by the surface of the wallpaper after the contraction of the force and the base of the separation of excessive water, resulting in some of the built-in bubbles. In fact, the solution is very simple, as long as the general sewing needle to the surface of the wallpaper to pierce the bubbles, the gas is released, and then use the needle to extract the right amount of adhesive into the pinhole, and finally the wallpaper back to flatten, dry You can.

 

2. The situation of mildew in the wallpaper The mildew in the wallpaper generally occurs in the rainy season and wet weather, mainly due to the excessive moisture in the wall. The solution for wallpapers that are not too bad for mouldy conditions is as follows: Wipe with a white towel with a proper amount of clean water, or wipe with soapy water. The best way is to go to a wallpaper shop to buy a special fungicide.

 

3, the situation of the wallpaper Alice may have the edge of the wallpaper is not clean, the adhesive strength is too low or the angle of the edge of the wallpaper is less than 2mm and other reasons, the solution: use wallpaper glue powder, wipe At the curling edge, smooth out the curls, blow it with a hair dryer for about 10 seconds, and then apply it by hand until it is firm and blown with a hair dryer to dry it.

 

4, on the wallpaper scrub with a damp cloth or dry cloth to scrub the place with dirt; can not use some colored raw materials to contaminate the wallpaper, otherwise it is difficult to remove; wipe the wallpaper should avoid the corner or behind the door to avoid, avoid Adverse reactions cause damage to the wallpaper.

 

Pvc wallpaper type

A, ordinary type ------ 80g / square meter of paper for the paper, coated with 100g/square meter PVC resin. The surface decoration method is usually a combination of printing, embossing, or printing and embossing.


B. Foaming-------100g/m2 paper is used as paper base, and 300-400g/m2 PVC resin is applied on the surface. According to the size of the expansion ratio, there are low foaming and high foaming, respectively. The high-foaming wallpaper surface has elastic concave and convex patterns and has a certain sound absorption effect.


C. Functional type ------ Among them, water resistant wallpaper is made of glass fiber cloth as base material, which can be used to decorate bathroom (bathroom decoration effect drawing) and bathroom wall; firewall paper uses 100-200g/m2 asb


Ё NEWS